Press "Enter" to skip to content

Auteur: BAussems

Spinning Sphere in a Glass Jar

Continuously Rotating Sphere in a Glass Jar

The best place for a rotating sphere, driven by solar energy, is in a glass jar. The electronic driver circuit and the mechanics consists of just a few components. The styrofoam sphere with a sharp needle as axis, rotates under a magnet bearing. The needle rests above against a small glass plate. Four magnets on top of the sphere, a solarpanel, a supercapacitor, a coil and a sensor are all the essential parts to keep the sphere spinning for a very long time.

Schematic diagram of the circuit
Short Video of the project

Parasite Pulser

This simple zapper has nice build-in features like a timer and a frequence sweep generator

A pulse device is often used in alternative medicine. Its primary goal is to boost the users immune system. It kills likely bacteria, viruses, fungi, toxins, etc. by applying very small currents through the body with a specific pulse and frequency. Dr. Hulda Clark promoted this method in the handbook for self-health and promoted the use of a Zapper. Dr. Royal. R. Rife made instruments based on a wide range of frequencies. This Parasite Pulser can scan some of Dr. Rife’s frequency tables. The various claims and counter claims about its effectiveness are all for what it’s worth.

Features of this Pulser:

  • Small case and a simple way to use. Low current, long battery life.
  • Wide frequency range from 10Khz to 200Khz, for multiple parasites
  • Sweep function around central frequence determined by the potmeter
  • Build-in timer what switch-off after 8 minutes

Activating the push button starts the circuit. By releasing the button the mosfet BS170 takes over the power line untill the 4040 disconnects the circuit after 8 minutes. The 4040 counter resets by start-up at pin 11. The counter clock is delivered by IC2a. 200 miliseconds (5Hz) is the time between 2 pulses. It makes (depending on the position of potmeter VR-1) a frequence sweep by the ramp generator build up around IC2a. The voltage controlled oscillator IC2b delivers a 1 microsecond pulse of 9Volt. The output current is limited to 9mA by the 1 Kohm resistor, that keeps operation shortcut save. The LED functions also as ‘on’ indicator for the device. The ground and the 1Kohm resistor are connected to the body by hand or wrist electrodes.

Potmeter position for frequency sweep:

Nanopower pulsemotor

Rotor with 5 magnets spins on a very sharp needle.

This ultra low power pulse motor has many features:

  • 3 Nano power smd ic’s drive the compleet project
  • Hall sensor detects the position of the magnet
  • Comperator ic is also pulse shaper and coil driver
  • Ultra low current consumption of 15uA average
  • Solar panel and SuperCap provide the power supply
  • Simple design keeps this motor continuously spinning
Complete diagram nano power pulse motor
Video shows more details about the construction and operation

Double spin pendulum

This pendulum makes a rare double spin movement

Last month I made a Pendulum with the following features:

  • 25 centimeter high suspension point.
  • Very low friction suspension point with magnet
  • Needle with weight touches glasplate
  • Magnet is hanging in horizontal direction
  • Ultra low power consumption, 20uA.
  • Pulse coil is also magnet sensor.
  • Solar panel and SuperCap energy supply
  • Simple construction and electronics
Electronic circuit and construction details
This video shows more details of the construction and operation